Published on Jul 29, 2016
Lets modify The Runner and The Mover to do some fun experiences.
We added a tail and removed the front load. It started running like a lizard. Then we modified the Mover. The front motor was disconnect form power. The rear motor was given power external supply. We found the C wheel helping the robot to jump and cross the gap. We tried with different voltage and different initial leg position.
How to make six legged robot - Hexa - DIY Robot
Published on Sep 23, 2016
Here is the step by step process to make a simple six legged DIY robot. Its single motor based robot. A plastic geared DC motor (100rpm) was used. The power source was a 3.7V li-po battery. But you can use two AAA battery too.
how to make a solar powered six legged robot - DIY Robot
Published on Sep 30, 2016
I took the robot Hexa, a six legged robot, which i made in my previous video. It was powered by a Li-Po battery. In this project we replaced the battery with a 5V, 160mA solar cell. This battery less robot was able to walk outdoor under sunlight. For further development, some can make it hybrid, by connecting both the solar cell and the battery. Solar power can be used during day time to charge the battery.
How to make six legged insect robot - DIY Robot
Published on Oct 14, 2016
How to make six legged insect robot - DIY Robot
Here are step by step instructions to make a six legged insect robot. It’s powered by one single geared dc motor. Legs are make for 2mm dia iron wires.
How to make a wheg climbing robot at home
Published on Jan 21, 2017
This is a simple wheg (wheeled leg) robot which can move on irregular surface as well as can climb iron wall. Before start making this wall climbing robot, please go through the video , make your own list of parts and collect those parts and tools. Basically you need:
Electronics components:
1. Dual shaft DC geared motor, 100 RPM.
2.A 3.7V, 100mAH – 200 mAH Li-Po battery.
3. Wires and male female connector.
Mechanical part:
Plastic case used for electrical wiring, 10mm bead, a paper pin, 8 pcs of neodymium magnets, two empty sketch pen, plastic sheet from a file cover. For more details watch the video.
Tools:
Hot glue gun, cutter, knife, soldering iron, set square, rulers, lighter etc.
Meet SinO - A wave robot
Published on Sep 26, 2017
Meet SinO. It is a single motor driven Robot. It does not have any active wheel.
It moves forward through it wavy motion. See, its motion is like a Sinusoidal wave. Yes, the
Sine wave you have read in your math text book. I hope by seeing the video you can make your
own robot, like SinO. If you face any difficulties, please wait till this week end. As usual I will show
Step by step process of making it.
How to make SinO – A Wave / Worm Robot
Published on Sep 29, 2017
As shown in the previous video, here is the step by step process of making it. Sino does not have any active wheel.
It moves forward through it wavy motion. See, its motion is like a Sinusoidal wave. Yes, the
Sine wave you have read in your math book. I have used a 60 RPM DC geared motor to generate the worm like motion.
Experiment: How to make SinO move on water
Published on Oct 3, 2017
Last week we made a robot named SinO, which does not have any active wheel. It moves forward because of its wavy worm like motion. Today we will do some experiment to see if it can move on water while floating.
Posting Permissions
Reply With Quote
Социальные закладки